SRP Pro 4032 Chevrolet LS Gen III/IV Piston – 4.065 in. Bore – 1.330 in. CH, -17.20 CC
SKU: 287997L
To order please contact customer support by phone at 1-714-898-9763 or by email at [email protected]
SRP Pro 4032, Chevrolet, LS Gen III/IV, 4.065 in. Bore, 1.340 CD, Inverted Dome/Dish, Left Piston
SRP Professional pistons combine forged piston durability with modern performance technology for an extremely capable forged piston kit that doesn’t break the bank. Forged from 4032 aluminum, SPR Pro pistons experience minimal thermal expansion, making them perfect for a high-performance, reliable engine build from the track to the drag strip. All SRP Pro pistons include premium ring sets, wrist pins and locks. As with all JE Pistons products, SRP pistons are made 100% in the USA.
- Forged in the USA using 4032 aluminum, yielding tensile strength and minimal thermal expansion
- Proprietary Forged Side Relief (FSR) forging design minimizes friction and power loss with reduced skirt width and saves additional weight with a shorter wrist pin
- Low-friction skirt coating reduces wear and reduces operating noise while optimizing performance
- Includes high-quality wrist pins, locks, and JE Pro Seal premium piston rings
- Accumulator groove helps reduce pressure from combustion gases, reducing ring fluttering and improving ring seal for consistent power
- Made 100% in the USA
GTIN: 00193564255556
| Piston Series | |
|---|---|
| Cylinder Head | |
| Bore Diameter | |
| Piston Head Type | |
| Compression Height | |
| Piston Volume | |
| Piston Material | |
| Forging Type | |
| Piston Orientation | |
| Piston Average Weight | |
| Ring Set Included | |
| Top Compression Ring Thickness | |
| Second Compression Ring Thickness | |
| Oil Ring Thickness | |
| Wrist Pin Outer Diameter | |
| Wrist Pin Length | |
| Wrist Pin Wall Thickness |
Makes
Chevrolet
Engines
LS Gen III/IV
Instructions: Enter a value in the un-shaded boxes below as they pertain to your engine.
Note: For pistons BELOW the block @ TDC – value in box must be a NEGATIVE number (-0.000)
Note: For pistons ABOVE the block @ TDC – value in box must be a POSITIVE number (0.000)
Note: For a DISH piston – value in box must be a NEGATIVE number (-0.0)
Note: For a DOME piston – value in box must be a POSITIVE number (0.0)
Note: Manipulate the DOME/DISH & PISTON to DECK volumes to get the ratio you want.