Share |
LS7 F.S.R. Dish

FSR (Forged Side Relief) slipper forging design accommodates factory stroke and rod length while easily clearing the reluctor wheel. These Heavy-Duty LS7 pistons are designed for extreme levels of Nitrous/Boost (Pin upgrade recommended above 700 HP). CNC-machined ring grooves accept 1.5, 1.5, 3mm rings. (CR calculated with .042 gasket thickness and 0.00" deck clearence). STOCK ROD MUST BE HONED TO ACCEPT .927" DIA PIN. MILLING OF ROD BALANCE PAD MAY BE NEEDED DUE TO VARIATION FROM FACTORY.

Includes:
Pin #927-2250-15-51C (111g)
Wire locks #927-073-MW
LS7 Series
Std Bore: 4.125
Ring package designed for: 1.5, 1.5, 3MM Rings
NOTE: Please check piston to rod clearance due to variation in factory rod top thickness. Milling of rod balance pad may be needed.

Click here to see matching JE Pro Seal Head Gaskets!

Tech and Installation Tips
Valve Relief Diagram
Part # CID Bore Stroke Rod
Lgth.
Block
Ht.
Comp.
Ht.
Head Cubic Centimeters
64cc 66cc 72cc
Compression Ratio
Dome
Vol.
Gram
Wt.
Footnote Oversize Recom.
Ring Set
279779 427 4.125 4.000 6.077 9.240 1.163 10.1 10.0 9.5 -22.0 434 B,C STD
279780 428 4.130 4.000 6.077 9.240 1.163 10.1 10.0 9.5 -22.0 436 B,C 0.005 J60008-4130-0

- Denotes part # has been issued a new part #. A list referencing old part #s to their new counterparts will be available shortly.


JE Pistons 10800 Valley View Street Cypress, California 90630 - Sales/Technical Assistance | Careers @ JE
Copyright © 2017 JE Pistons Inc. All Rights Reserved - Use of this site is subject to the following list of Terms & Conditions.